Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLING THE MAGNETIC STICKER PLATE
To charge your smartphone with the device, you can use
special magnetic cases or you can install the magnetic
sticker plate (H) on your smartphone.
•
Locate the charging coil of your smartphone by
holding the smartphone to the charging area (B).
Once your smartphone starts charging, you located
the charging coil and where the magnetic sticker
plate (H) needs to be placed.
•
Peel off the foil from the double-sided tape of the
magnetic sticker plate (H).
•
Place the sticky side of the magnetic sticker plate (H)
on the location of the charging coil of your smartphone.
•
Press for 10 seconds to secure the magnetic sticker
plate on the smartphone properly.
CHARGING YOUR SMARTPHONE
•
To charge your smartphone, place your smartphone
with the magnetic sticker plate (H) or magnetic
case on the device near the magnetic area (I). It will
automatically start charging.
•
To stop charging, remove your smartphone from
the device.
The device is equipped with a 'foreign object detection'
function. If a (metal) foreign object is detected, the
device will not charge for the sake of protection.
Note! If the distance between the charging area and
your smartphone is too big, the charging power is not
strong enough to charge your smartphone. This can
occur, for instance, if the (magnetic) case is too thick.
Note! Pay maximum attention to your driving. Handling
of the device and smartphone must not jeopardise your
safety in any way.
Note! To reach maximum fast charging capacity, the
device needs to be connected to a fast charging (9 Vdc –
2 A or 12 Vdc – 1.5 A) power source!
CLEANING
•
Before cleaning the device, always disconnect the
device from the charging cable.
•
Do not use abrasive cleaning solvents to clean
the device.
•
Clean the exterior of the device with a damp cloth.
4
4) SPECIFICATIONS
•
Input: 5 Vdc - 2 A, 9 Vdc – 2 A, 12 Vdc – 1.5 A
•
Wireless output: 5 Vdc – 1 A (5 W), 5 Vdc – 1.5 A
(7.5 W), 9 Vdc – 1.12 A (10 W), 12 Vdc – 1.25 A (15 W)
•
Operation frequency: 110 – 205 kHz
•
Transmitted power: 33.6 dBµA/m3@ (maximum
H-Field)
•
Dimensions: 10 x 6.5 x 3 cm (H x W x D)
•
Weight: 77 g
•
Charging cable length: 100 cm
All contents and specifications mentioned in this
manual are subject to change without prior notice.
INSTRUCTIONS FOR PROTECTING
THE ENVIRONMENT
(WEEE, the waste electrical and electronic
equipment directive)
Your product has been
manufactured using high quality
materials and components which
can be recycled and used again. At the end of its life
span, this product cannot be disposed of in normal
domestic waste but must be taken to a special
collection point for recycling electrical and electronic
equipment. This is indicated in the user manual and
in the packaging by the waste container marked with
a cross symbol. Used raw materials are suitable for
recycling.
By recycling used appliances or raw materials,
you are playing an important role in protecting our
environment. You can ask your local council about the
location of your nearest collection point.
Mascot Online BV
Veluwezoom 32
1327 AH Almere
The Netherlands
www.technosmart.nl
EN
Werbung
