whisker litter-robot 4 Installationsanweisung Seite 3

litter-robot· 4
by whisker
Installing the
Ramp Fence
Hinge and Ramp
If the newer fence is not installed on your Litter-Robot 4, follow
the steps below to install it. If your Litter-Robot 4 has the fence
already installed, please skip the first three steps.
0 Hold the fence upright inside the globe.
0 Gently press down on the back of the fence to snap it onto the bezel. Make
sure the fence is level.
0
Place the Ramp Fence Hinge over the top of the fence as shown.
Adjust the location left-to-right until centered. Press the area behind
the two small protrusions to snap it onto the edge of the fence.
0 Press the Reset button @ to zero the weight sensors.
G
+
0 Tilt the top of the fence toward you to align the front of the fence with
the bezel.
Note
0
The back of the Ramp Fence Hinge has two small protrusions, one on each side.
These are used to secure the Hinge to the edge of the fence.
0
Align the Ramp with the Hinge and press down to snap in place. Rotate the Ramp
down to the floor. The Ramp is now ready to use!
Questions?
Installation guide
How to install
Visit
whiskersupport.com