Konig & Meyer 19756 Nutzungsinformation Seite 6

Technical data
Material
Load capacity
Dimensions and
adjustment range
Packaging
Weight
Mounting
To mount the desktop smartphone stand, proceed as follows:
1.) Unpack and check product for damage and completeness
2.) Connect smartphone holder with swivel joint
Base, threaded bolt: Steel, powder-coated black
Smartphone holder, ball adapter, retaining arm, clamping nut: plastic
Support arm inside: Aluminum rod
Rubber pads: plastic, transparent
Smartphones and similar devices
Smartphone holder: width: 55-85 mm, height: 130-180 mm,
thickness max. 15 mm
Base: 148 x 144 x 4 mm
Height: ca. 200 mm
165 x 151 x 58 mm
0.62 kg
Smartphone holder
Holding arm with ball adapter
Base with threaded bolt
4x rubber pad
Assembly:
Place the holder arm on the threaded bolt 1, set the de-
sired position and hand-tighten the clamping nut on the
holder arm 2.
Note: To ensure a secure stand, align the smartphone
holder centrally above the base, see illustration.
Glue the four rubber pads to the underside of the base
with an even edge distance.
1 Open the clamping nut on the smartphone holder in
the UNLOCK direction until the swivel joint 2 snaps
into the smartphone holder with slight pressure.
3 Hand-tighten the clamping nut in the LOCK direc-
tion.
To adjust the position, loosen the clamping nut, set
the desired position, and hand-tighten the clamping
nut.