Grundig GIEH 834480 P Installationsanleitung Seite 22

before installed. The quantities of parts
that can be used in the installation may
vary according to the installation location.
• All parts that can be used in the
installation are given in table C9. You may
see the part code of the company for
same part is in the Y column.
Electrical connection of the appliance
(Figure E)
Connect the appliance to a grounded
•
outlet/line protected by a fuse that
is compatible with the values in the
"Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or
without a transformer. Our company shall
not be liable for any problems arising
due to the product not being earthed in
accordance with the local regulations.
Disconnect the appliance from the
•
electric connection before starting any
work on the electrical installation. Risk of
electric shock.
The appliance may only be connected
•
to the mains electricity connection by
an authorized and qualified person.
The manufacturer shall not be held
responsible for any damages that may
occur as a result of operations performed
by unauthorized persons.
The appliance must be installed
•
in a way that it can be completely
disconnected from the mains supply.
The disconnection shall be provided by
a switch built into the fixed electrical
installation, according to the construction
regulations.
The bottom surface of the cooker gets
•
hot, too, when it is in use. Electrical
connections shall not contact the bottom
surface, otherwise the connections may
be damaged.
Do not pass the connection cables
•
over the hot surfaces. Otherwise, cable
insulation may melt and cause fire as
a result of short circuit of the cooker. If
the electric cable is damaged, it must
be replaced by a qualified electrician.
Otherwise there is a risk of electric shock,
short circuit or fire hazard!
While performing the wiring, you shall
•
comply with the national/local electrical
regulations and shall use the appropriate
22
socket outlet/line and plug for the cooker.
In case the product' s power limits exceed
the current carrying capability of plug
and socket outlet/line, the product must
be connected to the fixed electrical
installation directly without using plug
and socket outlet/line.
Make sure that fuse rating is compatible
•
with the product.
Connection must comply with national
•
regulations.
The mains supply data must correspond
•
to the data specified on the type label of
the product. You may see the type label
on the bottom of the cooker.
Power cable of your product must
•
comply with the values presented in
"Technical specifications" section.
If the appliance shall be directly
•
connected to the mains: If it is not
possible to disconnect all poles in the
mains supply, a disconnection unit
with at least 3 mm contact clearance
(fuse, line safety switch, contactor) shall
be connected and all the poles of this
disconnection unit shall be adjacent to
(not above) the appliance in accordance
with IEE directives. Failure to obey this
instruction may cause operational
problems and invalidate the product
warranty.
Additional protection by a residual current
•
circuit breaker is recommended.
If your appliance has a cord and plug:
Perform the electrical connection of your
•
appliance by plugging it to a grounded
socket.
If your appliance has a cord, but does
not have a plug:
Connect your appliance to the mains as
•
specified below as per the cord type. The
cord type of your appliance is specified in
the "Technical Specifications" section of
the operation manual.
If your supply cord type is 5-conductor type, for
1-phase connection:
For single phase connection
- (BRW/BLA) Brown/Black = L (Phase)
- (BLU/GRE) Blue/Grey = N (Neutral)
- (GR/YE) Green/yellow wire = (E)
(Earthing)