egger EL 1 Betriebsanleitung Seite 14

egger EL 1
• Do not pull the mains plug out off the socket at the
mains cable.
• Should the mains cable be damaged, it must be
replaced at once. Defective mains cables must not
be used.
• The device must be repaired by the manufacturer
only.
• The unit must be switched off during service and
maintenance operations (cleaning, replacing of UV-
bulbs or reflecting foil). Pull the mains plug before!
• On replacing use the original egger light tubes and
reflectors only.
• Do not use any dissolvent when cleaning the device.
Do not immerse the unit in liquids.
• Children must be kept away from the unit!.
!
On self-accomplished repairs or if other spare parts
are used, all warranty and liability claims will become
extinct!
3 Installation, Handling and Initial Operation
3.1 Scope of delivery
Please check whether the delivery is complete and whe-
ther all parts are free from transport damage. Immedia-
tely inform us or the distributor about missing parts or
transport damage.
• The UV-curing unit egger EL 1 consists of:
• 1 light protection cover
• 1 mains cable
• 1 metal plate for lacquering operations
• 1 operating instructions and processing manual
14
3.2 Technical data of the light-curing unit egger EL 1
Power supply: 230 V +/- 10% (or 115 V )
Mains frequency: AC 50 Hz
Connection: mains plug Schuko (German) (or US)
Power input: AC 250 VA
3.3 Spare parts and accessories for the light-curing
unit egger EL 1
UVA-light tube
Blue-light tube
Rectangle socket
Light protection cover
Set of reflecting foils
Plastic plate transparent REF 51103
Timer
3.4 Assembling and connecting the unit
The electrical light-curing unit egger EL 1 corresponds to
the state-of-the-art standards and to the acknowledged
safety regulations, nevertheless dangers can arise.
Please observe the following, before putting the unit into
operation:
• Qualified and trained persons must use the device
only.
• Please adhere to the safety regulations accepted.
• Use the unit when in perfect and clean condition only
and observe the operating instructions.
• Position the device horizontally and place it in its
suitable working position.
• Remove the protection foils and the light protection
cover off the workbench.
• Protect the unit against impact.
• Check, whether the unit is dry.
• Check whether the device is in technically perfect
condition, especially the mains cable!
• Plug in mains cable.
REF 50103
REF 50104
REF 50107
REF 51102
REF 51104
REF 51109