egger EL 1 Betriebsanleitung Seite 13

1 General
The light-curing unit egger EL 1 was developed to po-
lymerize light-curing resins for the manufacturing and
surface lacquering of BTE and ITE earmolds.
This unit can process all kinds of egger LP materials as
well as materials of different consistency and pigmenta-
tion from an external manufacturer.
The light tubes (UV and blue light tubes) are arranged on
different levels and can be switched on and off depen-
ding on their use. Consequently, this guarantees an opti-
mal surface and depths polymerization. The built-in con-
trollable ventilator avoids the light chamber to overheat.
This device can simultaneously polymerize 12 ITE or 8
BTE earmolds when using negative forms with a diame-
ter of 50 mm.
The light-curing unit egger EL 1 was especially develo-
ped for the following applications and is characterized by
• maintenance-free working
• fast exchanging of the UV tubes
• easy handling
• easy-to-clean powder-coated metal casing
In addition, we can offer you a variety of devices and
useful accessories out of our wide range of products.
Request our catalog or visit our homepage www.egger-
labor.com. In case you need personal advice, we will be
at your disposal.
2 Safety Regulations
!
The electrical light-curing unit egger EL 1 is used for
the polymerization of UV-curing LP materials, modeling
pastes and lacquers. A use other than described in the
operating instructions may lead to injuries of the opera-
tor or of third persons. Furthermore, the device or other
material assets may be damaged. Therefore, the device
must be used in technically perfect condition only and the
safety regulations must be strictly complied with.
!
2.1 For a safety conscious work environment
• Protect the unit from dust. Use the unit on dry wor-
king places only.
• Qualified and trained persons must use the device
only.
• Before putting the device into operation, the user
has to read the operating instructions and ask the
manufacturer in case of any questions.
• Use the unit in perfect and clean conditions only and
with full operational UVA blue light tubes.
• Before switching on the device, the light protecting
cover has to be attached.
• Do not cover the ventilator of the unit. Do not put any
items through the venting slot.
• Connect the device to permissible sockets only.
• Please adhere to the acknowledged safety regulations.
• This device is used for the processing of UV-curing
materials in a spectral range of 360 – 390 nm.
Please also adhere to the processing manual for each
material to be worked with.
egger EL 1
13