Switching The Machine Off; Cutting Operation; Cutting End Pieces - Hofmann A2707 Betriebsanleitung

• Put the support on the carriage so that the spiked
plate faces the blade and press the angled edge
onto the plastic sleeve on the last slice clamp rod.
Section 5 describes how to attach and detach the
EN
carriage itself.

4.2. Cutting operation

Warning!
Rotating blade! May sever fingers. Do not
reach into the running blade !
• Pull the carriage all the way back.
• Lift the last slice device
• Place the product at the rear carriage wall
• Place the last slice device from the top on to the
product
• Press the green on button. The machine will start
operating.
• Lift the last slice device
• Push the carriage forward and backward for cut-
ting.

4.3. Cutting end pieces

Press the green on button. The machine will start
operating.
Push the carriage forward and backward for cutting.
Press the product with the end
piece holder against the top plate.
20

4.4. Switching the machine off

• Press the red off button.
• Turn the adjusting knob for the cutting thickness
clockwise to top, beyond - 0 - to cover the blade
edge.
5. Cleaning
The machine has to be cleaned thoroughly at least
once a day.
Warning !
Rotating blade ! May sever fingers. Switch
the machine off prior to cleaning. Remove the
mains plug. Always wear protective gloves
with writ protection for cleaning the blade.
Important !
Please observe the sequence given for cleaning.
Do not use any scouring agents to clean the
machine, as they scratch the metal surface and
thus have a negative effect on hygiene.
Only use commercially available detergents
and hygiene agents. Neutralise aggressive de-
tergents and hygiene agents after cleaning.
Never use a steam or high pressure cleaner to
clean the machine ! In case of non-observation
of the above points our warranty will become
ineffective.
5.1. Preparation
• Press the red off button.
• Remove the mains plug from the socket.
• Turn the adjusting knob for the cutting thickness
clockwise up to the stop, beyond - 0 -, so that the
face of the knife is covered.
5.2. Detaching the carriage
• Pull the carriage all the way back.
• Unscrew the knob on the base of the carriage.
• Lift the carriage out of the base with both hands,