Werbung
Verfügbare Sprachen
Verfügbare Sprachen
uk │ 5. Technical data
5. Technical data
For technical data, refer to the rating plate [T].
Nominal voltage
Power frequency
Power consumption, max.
Contact (Relay R1)
Contact material
Switched current, max.:
at cos φ = 1
at cos φ = 0,4
Maximum load
inductive load
ohmic load
Maximum switching power:
at cos φ = 1
at DC
Switching point adjustment
range (Set point)
Hysteresis fixed
Degree of protection:
Control unit
Measuring probe
Overvoltage category
Degree of contamination
Installation height
Weight:
Control unit
Measuring probe
10
6. Safety instructions
6.1 General
230 VAC
● Read these operating
50 Hz / 60 Hz
4 VA
Changeover
● Assembly and electrical con-
contact,
potential-free
AgNi,
cadmium-free
● The degree of protection
10 A
5 A
2 A
5 A
2500 VA
● Only connect unit to
240 W
min. 1 m/s
max. 20 m/s
approx. 3.5%
of setpoint,
min. 0.05 m/s
IP 30
IP 20
● The unit may only be opera-
II
2
up to 2,000 m
above sea
level
● Only operate the unit when it
0.20 kg
● Modifications and alterations
0.12 kg
instructions carefully before
mounting and commissioning.
nection may only be under-
taken by trained specialists in
accordance with Chapter 2.
stated on the rating plate is
only guaranteed if installation
is undertaken correctly and if
the cables are correctly fed
into the terminal box.
permanently wired electrical
installations with NYM-O or
NYM-J, 0.75 x 1.5 mm² cables.
Additionally, a mains isolation
device with contact openings
of at least 3 mm at each pole
must be installed.
ted using the voltage and
frequency shown on the rating
plate.
is completely installed.
to the unit are not permitted
and release the manufacturer
from any guarantee and
liability.
Werbung
