Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TRP 150 X
This function is enabled in automatic mode and can
be disabled.
Press the
key to switch off the device.
Simultaneously press the
options are displayed:
Option 1: ECO mode (default setting)
Option 2: Comfort mode
Option OFF: Presence detection disabled
Press the + and - keys to select the preferred op-
tion.
Press the
key for 3 s to save the setting. The
display will show
NOTE
The "Frost protection" and "Heating off" commands
via the pilot wire always take priority.
Display
Command via
pilot wire
Option 1
Comfort
Eco
Absence
Comfort
Eco
Presence
Option 2
Comfort
Absence
Eco
Presence
6.9. Boost
Briefly press the
key to operate the device at max-
imum heat output for an adjustable time. Available
time settings: 5 to 30 minutes in 5 minute increments,
then 45 minutes, 1 hour, 1.5 hours, 2 hours. Select the
time using the + and - keys. Press the
save the setting for future use.
Briefly press the
key to switch off boost mode.
www.dimplex.eu
and
keys until the
.
Result
Constant lowering to
ECO (1.5 h)
ECO mode
Immediate switch to
comfort mode
ECO mode
Constant lowering to
ECO (1.5 h)
Immediate switch to
comfort mode
key for 3 s to
6.10. "Smart Boost" function
Automatic boost function as soon as presence of a
person in the room is detected. Boost mode is only
active if a person is present in the room and is used to
quickly increase the room temperature.
In the internal programming (see see section „6.14. In-
ternal programming") you can set the time periods for
comfort mode. Enabling the "Smart Boost" function
automatically activates boost mode as soon as the
presence of a person is detected. The duration corre-
sponds to the time set for boost mode. In a comfort
time range, boost mode can only activated automati-
cally.
For activation of the "Smart Boost" function see sec-
tion „6.13. Setting other functions".
6.11. Easy key lock
Locking
Unlocking
6.12. Key lock with numerical code
Lock key entry with a four-digit numerical code.
Locking
Press the + and – keys simultaneously for 10 s.
CLEF 1 is displayed after 3 s. After a further 7 s,
CODE flashes and the
Confirm with the
will flash.
Use the + or – keys to select the desired digit for
the first position.
Confirm with the
tion will flash.
Proceed in the same way for all four code positions.
After confirming the fourth position, the set tem-
perature and the
2302/A
Press the + and – keys simultaneously
for 3 s until CLEF 1 and the symbol
are displayed.
The device is now protected against
unauthorised access to the settings
and only the on/off key can be oper-
ated.
Press the + and – keys simultaneously
for 3 s until CLEF 0 is displayed and the
symbol
disappears.
symbol is displayed.
key. The first code position
key. The second code posi-
symbol will be displayed.
English
EN-7
Werbung
Inhaltsverzeichnis
