Werbung
E - GEAR INSTALLATION
Gear mounting bracket
F - SAFETY CABLE
2500mm/98.42in
Rev D | 10-2023
355mm/13.97in
1. No sharp edges on the interface (brackets or
hole) of mounting site.
2. In the below cases the safety chain must be
replaced with immediate effect:
a, If the safety chain was tightened once by the
luminaire falling down.
b, If part of the steel wire is broken.
During luminaire replacement, safety chain pro-
tects the luminaire from falling, but it's not allowed
to suspend the luminaire for a long period by it!
Steel safety cable should pass through the holes
shown in the drawing in sequence.
Then connect the two ends with the lock buckle
and tighten the lock bolt by hand.
For installations over 3m height:
safety system application is mandatory, which
is appropriated for the luminaire load (e.g. safety
cable).
2500mm/98.42in safety cable is supplied with the
luminaire.
www.schreder.com
8 x
M6
20±1Nm
5
8 x
M8
34±1Nm
6
NOTICE
*
secondary
6/11
Werbung
