Braun SI9270WH Bedienungsanleitung Seite 15

caused by the chemical or electrochemical
effects of water.
Under no circumstances shall the application of this
guarantee give rise to the complete replacement of
the appliance or entitle the consumer to damages.
Braun Household, New Lane, Havant,
Hampshire PO9 2NH
Troubleshooting Guide
PROBLEM
Water droplets drip on the fabric
during ironing
The iron produces little or no
steam
Flakes and white impurities
come out of the soleplate
during ironing
The spray function or the steam
shot do not work properly
Soleplate is not heating up
The temperature control LED
turns permanently on
Water droplets drip from the
soleplate after the iron has been
unplugged or has been stored
14
TS 7 Pro
Press the water tank lid and check if it is closed
Check that the temperature
selector is at least on ••. Select a
higher temperature setting. Take
longer intervals when pressing the
steam shot button.
If chemicals have been put into the water tank, empty the water tank,
Check that the temperature
selector is at least on ••.
Perform the descaling procedure
Unplug the iron and plug in again.
Rotate the temperature selector
from «min» to «max». Then select
the desired temperature.
n/a
Empty the water tank after ironing and place the iron vertically on a stable
www.braunhousehold.co.uk
Thank You for choosing Braun. We are confident
that you will get excellent service from this product.
TO IMPROVE YOUR EXPERIENCE
Register now at www.braunhousehold.co.uk
By registering we may send you from time to
time details on exclusive offers, promotions,
recipes and inside tips.
SOLUTION
Take longer intervals when pressing
the steam shot button.
rinse it 2-3 times.
Check water level and refi ll tank
Perform descaling procedure
Wait until the iron heats up and
the temperature control LED is
permanently ON.
Refi ll the water tank
n/a
Unplug the iron and plug in again.
If the problem does not disappear
contact the Braun customer service.
Set the steam regulator to «0»
surface during cooling down
TS 9