Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Any other use is considered improper and thus dangerous.
• The manufacturer is not liable for damage caused by inap-
propriate, incorrect or irresponsible use or for damage resul-
ting from repairs carried out by unqualified personnel.
Important!
The machine works with normal tap water.
In case of very hard water (hardness above 27°f) we suggest
using demineralised water diluted with 50% tap water.
Never use chemical substances or detergents (e.g.
perfumed water, essences, descaling solutions, etc).
Do not use mineral water or other types of water (e.g.
rainwater, water for batteries, conditioners etc.)
Important!
If you use filtering devices, make sure the water obtained has
a neutral pH.
Using the appliance for the first time
• The first time you use the iron, remove the plate protection
(if present).
• When used for the first time, the appliance may give
off smoke and an odour for several minutes. This is
caused by heating and subsequent drying of the sea-
lers used in assembling the appliance.
You are recommended to ventilate the room.
• Always place the steam regulator on
reservoir (fig. 2).
Ironing tips
• The original appearance and softness of fabrics such as
velvet or wool, or gloves, bags etc. can be restored by pas-
sing the iron a short distance away with the steam jet in
operation.
• Do not rest or use the iron on zips, hooks, rings etc to avoid
scratching the sole plate.
• Separate clothes according to the recommended ironing
temperature and begin ironing with items requiring the
lowest temperatures.
• Silk may be dry-pressed on the reverse.
• Wool, cotton and fine linen can either be steam-ironed on
the reverse or on the right side, interposing a thin cloth
between the iron and the fabric to avoid "shine".
• Starched fabrics require greater moisture.
• Iron whites and light colours on the right side and dark co-
lours on the reverse. Embroidery should also be ironed on
the reverse to make it stand out.
To obtain a good steam jet, wait a few seconds between
one burst of steam and the next.
Description
A. Power cable
B. Steam ready light
C. Spray button
D. "Easy Turbo" button (steam burst)
E. Steam regulator
F. Tank fill hole cap
G. Spray
H. "Self Clean" button
I. Thermostat dial
L. Water measure
Self Clean (page 5)
Over time, the lime in the water causes scale to build up inside
the iron.
To prevent the scale reducing steam production, you should
perform the "Self Clean" procedure every two weeks.
Proceed as described on page 5:
• Place the steam regulator on
(fig. 15).
• Plug the appliance into the mains and place the thermostat
in the MAX position (fig. 16). The "steam ready" light comes
on;
• When the "steam ready" light goes off (the iron is at tempe-
rature) (fig. 17), unplug the appliance from the mains (fig.
18).
• Hold the appliance over a sink, press the SELF CLEAN button
before filling the
and, holding the button down, shake the iron delicately for-
wards and backwards (fig. 19). Residues of scale and other
impurities mixed with boiling water come out of the sole
plate.
• Release the SELF CLEAN button.
• Plug the appliance into the mains socket and leave in ope-
ration for at least two minutes to dry the plate (fig. 20).
• Unplug the appliance from the mains socket and wipe the
sole plate with a cloth to remove any residues (fig. 21).
• Leave the iron to cool down completely, then put away.
9
description
en
and fill the water reservoir
Werbung
