Hama IT900MBT Kurzanleitung Seite 7

5. Before getting started
Notes on use
The streaming tuner is operated only using the UNDOK
app and your smartphone.
Note
A detailed description of the
UNDOK app and the full
scope of functions can be found
in our UNDOK guide at:
www.hama.com - > 00054861 - > Downloads
6. Getting started
6.1 Connections
• 1 x Line out 3.5 mm
• 1 x Optical connection
• 1 x USB Type-A playback / update port
• 1 x Power supply (Micro-USB)
6.2 Turning on the product
• Connect the supplied Micro-USB charging cable to the
tuner's Micro-USB port (4).
• Connect the unused connector on the Micro-USB
charging cable to the USB charger.
Hinweis
Only use original accessories (or accessories approved
by Hama), to prevent damage to the product.
• Connect the power cable / power supply unit to a
properly installed socket.
Warning
• Only connect the product to a socket that has been
approved for the device. The electrical socket must
always be easily accessible.
• When using a multi-socket power strip, make sure
that the sum power draw of all the connected devices
does not exceed its maximum throughput rating.
• The electrical socket must always be easily accessible.
• If you will not be using the product for a long period
of time, disconnect it from mains power.
• Wait until the tuner initialisation procedure has finished.
• Briefly press the [POWER] button (1) on the device.
Note – Turning on for the rst time
• When you turn on the device for the first time, the
tuner starts in SETUP mode.
• The status LED (2) begins to flash white. The tuner
can be connected to your smartphone only using the
UNDOK app.
• If connection problems occur, you can switch the
tuner back to SETUP mode by pressing and holding
the [POWER] button (1).
Adjusting/muting the volume
Entering passwords, search terms, and so on
Entry is only using the UNDOK app.
Turning on/off / Standby / Micro access point
• Press [POWER] to turn the tuner on. Alternatively, the
tuner may be switched on using the UNDOK app.
• Press [POWER] to turn the tuner off (standby). Once a
network connection has been set up, it too will be kept in
standby mode, to enable the device to be turned on using
the UNDOK app.
Note
To completely switch off the device, disconnect it from
the power supply.
7. UNDOK – everything in the palm of your hand
The UNDOK app, developed by Frontier Silicon, gives you
full control of radios and speakers from your smartphone.
Whether you are setting up the device for the first time,
specifying settings for multi-room, or managing your
favourite stations – the UNDOK app lets you access all the
features from your smartphone or tablet.
Below is an explanation of how to set up the tuner for the
first time with UNDOK. The full range of functions of the
device can be accessed only using the UNDOK app.
3