Werbung
B
WARNING!
Do not connect a damaged cable or touch the damaged cable before disconnecting
from the network. This can cause an electric shock. In case of damage to the supply,
have it replaced by an authorized service centre. This prevents a dangerous situation.
•
Do not expose to rain or use in damp or wet conditions.
•
Do not use in environments with a risk of fire or explosion.
•
Prevent spontaneous fall of small objects into the product.
•
Never use brute force.
•
Disconnect the supply (by pulling out the plug from the socket for example):
- Allways, when the machine is without supervision
- Before eliminating of blocking
- Before checking, cleaning or work on the machine
- After crash into another subject
- Allways, when the machine beginns vibrate unreasonably
- When transporting
ELECTRICAL REQUIREMENTS
•
Never use at the nominal voltage other than 230V/50Hz. The circuit must be properly and
accordingly current protected.
•
Only connect to an electrical circuit that is protected by the current protector with actuating
current not exceeding 30 mA.
I
In case of doubt, it is advisable to check with your electricity supplier or your electrician
Note:
if your house connection meets the requirements.
EXTENSION LEAD
•
Always use a double-insulated power supply and the parameters corresponding to
the machine's power consumption. The minimum cross section of the cable must be
determined according to the current or power data on the fork/label of the machine. It's not
only necessary to take the load into account, but also the length of the extension lead and
the type of fuse.
•
Position power supply cable so it does not interfere with the work and is not damaged.
•
Only use rubberised extension cables with sufficient conductor cross section and fully
developed.
Minimum cross-sections of the e fully developed extension cord:
- up to 6 A including: > 0.75 mm2;
- up to 10 A including: > 1.0 mm2;
- up to16 A including: > 1.5 mm2;
Maximum cable length in relation to the cross section
Cable cross section (mm2)
Maximum possible length (m)
•
The correct maximum load of the extension cable must always be indicated on its label.
0,75
1
30
40
1,5
2,5
60
100
EN
DE
CS
SK
PL
HU
17 / 32
Werbung
