JVD RB9391 Bedienungsanleitung Seite 19

All setting modes will automatically exit in 15 seconds without any adjustment

When the time in 12 hour format, for example: alarm time

morning, alarm time
For Time Zone: If you receive no RC-DCF frequency signal, the time zone should be set to 0. Time

Zone is used in countries which can received the DCF frequency signal but the time zone is
different from German Time ( i.e. GMT+1).
4.2 Daily Alarm Setting:
Press "ALARM SET " button to toggle display between "ALARM TIME" and "DATE".

Hold "ALARM SET " button 2 seconds, alarm time flashes, press "+" or "-" button to adjust the

alarm time. Press "ALARM SET " button to confirm the setting.
By keeping the "+" or "-" button pressed, could speed up the setting.
4.3 Snooze Alarm Function:
Slide "ALARM ON/OFF" switch to " " (B1) to activate alarm function, Slide "ALARM ON/OFF"

switch to " " (B1) to deactivate alarm function.
Alarm icon" " displays on LCD if alarm function is activated.

When alarm is alerting, alarm icon " " flashes. Light touch "SNOOZE" button to activate the

snooze alarm, (" " flashes on the LCD). The alarm will snooze for around 5 minutes, then it
alarms again. This snooze function can be enabled for maximum 7 times.
Except "SNOOZE" button, press any buttons to stop the snooze alarm. Otherwise, the alarm signal

sounds for about 2 minutes, and then stops automatically.
5. Thermometer
Press "℃/℉" button to switch temperature unit.

If the temperature is out of the measurable range, LL.L (beyond the minimum temperature) or

HH.H (beyond the maximum temperature) will be shown on the LCD.
Note: when the temperature is over 50°C, the LCD might not be able to display the functions
properly.
6. Backlight
Light touch "Light " button, back light states for 5 seconds.
7. Lock/Unlock
Slide "LOCK /UNLCOK " slide switch to lock the button function. When the function is lock,

icon " " display on LCD.
means 10 o'clock at night.
means 8 o'clock in the
19