Charging The Batteries With The Usb Charging Cable; Charging The Batteries With The Collector Panel; Set-Up Location Requirements - FLORABEST FTUS 3.6 A1 Originalbetriebsanleitung

Charging the batteries with the USB charging cable

♦ You can charge the supplied batteries
using the USB charging cable
rubber plugs from the connection socket
charging cable
USB charging cable
Charging takes between 5 and 10 hours depending on how
much the batteries
NOTE
► The red LED

Charging the batteries with the collector panel

♦ During the day, the solar cells convert sunlight into electricity and
charge the batteries.
♦ The number of operating hours depends on how long and
intensively the sun shines on the collector panel
results, place your solar lamp at a location where sunlight shines
directly on to the collector panel
8 hours duration is ideal for completely charging the batteries.
The location must be free from shadow and shade.
♦ Ensure that the movement sensor
sunlight or other light sources. This can result in malfunctions.

Set-up location requirements

This device complies with protection class IP44. This means that the
device is protected from dust and water spray, and can be used re-
gardless of the weather conditions. However, proper protection from
water spray is only provided if the device is correctly closed and all
seals are intact and clean.
Please be aware that protection from water spray is only provided to
a limited extent if the USB charging cable
FTUS 3.6 A1
into the connection socket
with your computer or a USB adaptor.
have discharged.
fl ashes during charging.
directly in the device
provided. First, remove the
. Now insert the USB
and connect the
. Direct sunshine of at least
is not infl uenced by direct
is used.
. For the best
41
GB