Herunterladen Diese Seite drucken

EuroLite ZEITGEIST FOG-1000 Bedienungsanleitung Seite 19

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

6
INSTALLATION
Place the machine on a plane surface or mount it via its bracket.
• Install the device in a well-ventilated area. The operation in an insufficiently ventilated room can lead to a
condensation of the fog fluid. The resulting slippery surface can cause accidents.
• Keep a minimum distance of 20 cm around and above the device.
• Furthermore, do not orientate the escape nozzle directly in the direction of the audience's eyes. In order to
create a good effect, there should be a distance between the device and the audience of at least 1.5 m.
• Only install the fog machine on scratch resistant and water resistant surfaces.
• Please make sure that the inclination angle does not exceed 15°.
Mounting Bracket
Screw the mounting bracket to the machine using the included set of screws. Place the washers on the
inside of the bracket and adjust the desired inclination angle. Tighten the fixation screws.
Overhead Installation
Consider the EN 60335-1:1996 and the respective national norms during the installation!
Installation by authorized dealers only!
Before taking into operation for the first time, the installation has to be approved by an expert!
If the device is to be installed overhead, the following safety instructions are binding:
• The installation of the device has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
• The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
• When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
www.eurolite.de
DANGER TO LIFE!
DANGER TO LIFE!
19

Werbung

loading