CMCO TIGRIP TPP Originalbetriebsanleitung Seite 14

14
U O T L L A
SAGE F HE OAD IFTING TTACHMENT
In the "OPEN" position of the lever, the clamping jaw is locked in the open position. In this
position, push the load lifting attachment onto the load until the load has fully entered the
mouth of the clamp. By switching the lever to the "CLOSE" position, the clamping jaw is
released. The clamping jaw is firmly pressed against the load by spring pressure force. This
ensures that the applied load lifting attachment remains clamped to the load precisely as a
result of the spring pressure force also without any pulling force. The load can now be lifted
and transported. At the end of the transport operation, the suspension (e.g. hook, shackle,
etc.) must be lowered until the load lifting attachment is completely load-free and/or the
suspension eye can be moved freely. The lever can now be switched to the "OPEN" position
again and the load lifting attachment can be removed from the load.
NOTE: If the lever cannot be switched over, a light tap on the suspension eye with a hammer
should release the load lifting attachment.
I / S
NSPECTION ERVICE
According to national and international accident prevention and safety regulations hoisting
equipment must be inspected:
• in accordance with the risk assessment of the operating company,
• prior to initial operation,
• before the unit is put into service again following a shut down
• after substantial changes,
• however, at least once per year, by a competent person.
Attention: Actual operating conditions (e.g. operation in galvanizing facilities) can
dictate shorter inspection intervals.
Repair work may only be carried out by specialist workshops that use original TIGRIP spare
parts. The inspection (mainly consisting of a visual inspection and a function check) must
determine that all safety devices are complete and fully operational and cover the condition of
the unit, suspension, equipment and supporting structure with regard to damage, wear,
corrosion or any other alterations.
Initial operation and recurring inspections must be documented (e.g. in the CMCO works
certificate of compliance).
If required, the results of inspections and appropriate repairs must be verified.
Paint damage should be touched up in order to avoid corrosion. All joints and sliding surfaces
should be slightly lubricated. In the case of heavy contamination, the unit must be cleaned.
Repairs may only be carried out by specialist workshops that use original TIGRIP spare
parts.
After repairs have been carried out and after extended periods of non-use, the load lifting
attachment must be inspected again before it is put into service again.
The inspections have to be initiated by the operating company.
©
2016 Columbus McKinnon Industrial Products GmbH