Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Description of the functions
After the machine starts heating up, the display below HEAT flashes. When the machine is ready for fogging,
the display shows "OK".
Via the Function key, you can move in the menu. Press the Function-key until the value of the desired
function starts flashing. Via the Up/Down-buttons, you can adjust the desired function values or change the
selection. In this way, you can adjust the functions of the smoke-machine the best way to the requirements
of the user. The individual functions are desribed in the following.
LCD-display
MU
01-99 (minutes)
SE
Timer mode
01-99 (seconds)
VO
01 minimum - 10 maximum
DE
Manual mode
01-99 (seconds)
HEAT
Heating
flashing = heating phase
phase
Ok = ready
Timer mode
By pressing the Timer-button, the device works with the adjusted settings (MU, SE and VO). The green LED
below the Timer-button shows that the Timer-function is activated. If you wish to deactivate the Timer-
function, press the Timer-button again.
Manual mode
By pressing the Manual-button, the fog emission is immediately triggered with the duration adjusted under
"DE". The Manual-mode is automaticall stopped after the duration you defined or by pressing the Manual-
button again.
Description of the elements:
(1) LCD-display
(2) Up-button
(3) Function-button
(4) Down-button
(5) Timer-button
(6) Output-button
(7) Continuous-button
Function
Adjust the interval between each fog emission
Adjust the duration of each fog emission
Adjust the output volume
Adjust the duration of each fog emission
Display of heating phase
19/40
00033330.DOC, Version 1.1
Werbung
