(System Set)" Submenu; System" Function - Reely Gen7 Bedienungsanleitung

10.14 "(SYSTEM SET)" submenu

This submenu contains various configuration options.
Proceed as follows:
Select the "(SYSTEM SET)" submenu as described in chapter 10.6. After confirm-
ing with or , the first option "SYSTEM" is highlighted, as shown in fig. 46.
Use or to select the desired function; press
After that, you can change the relevant settings depending on the function, as
described in the following chapters.

10.14.1 "SYSTEM" function

This function is used to set the battery type, display contrast, alarm tones and volume.
Proceed as follows:
After selecting the "SYSTEM" function as described in chapter 10.14, the display
should look like the one shown in fig. 47.
Use or to choose between:
– „LANGUAGE" = Set the menu language
– "IDLE ALARM" = Alarm tone that sounds after a preset time without operating
the transmitter and reminds you to power off the transmitter
– "BATTERY" = select battery type ("AA BATTERY" = 4 AA/Mignon batteries, "2S LiPo" = 2-cell LiPo recharge-
able battery, "OTHER" = other battery type with adjustable voltage)
– "LCD" = Set the display contrast
– "LED" = Switch the LED ring (7) on/off
– "SOUND" = Switch transmitter signal tones on/off ("ALA" = alarm tones, "SYS" = button operation)
– "VOLUME" = Set the volume of the transmitter signal tones
After pressing or , the display starts to flash.
Use or to change the setting.
Press to exit the setting. The current setting is saved.
Proceed with the next setting as described. Press
or to confirm your selection.
to go one menu level back or exit the submenu/setup menu.
Figure 46
Figure 47
71