10.13 "(MODEL)" submenu
The transmitter has 20 model memories in total. You can use them to operate up to 20 model vehicles or to store
multiple settings for one model vehicle.
Proceed as follows:
Select the "(MODEL)" submenu as described in chapter 10.6. After confirming with
or , the first option "SELECT" is highlighted, as shown in fig. 41.
Use
or
to select the desired function; press
After that, you can change the relevant settings depending on the function, as
described in the following chapters.
10.13.1 "SELECT" function
This function enables you to select one of the 20 model memories.
Proceed as follows:
After selecting the "SELECT" function as described in chapter 10.13, the display
should look like the one shown in fig. 42.
Use
or
to select the desired model memory.
Press
or
to confirm the selection.
A confirmation prompt will appear on the screen. Use
"OK" (select model memory) and "CANCEL" (abort). Press
tion.
Proceed with the next setting as described. Press
10.13.2 "NAME" function
By default, the model memories are named "MODEL 01" ..... "MODEL 20". This function enables you to rename them.
Proceed as follows:
After selecting the "NAME" function as described in chapter 10.13, the display
should look like the one shown in fig. 43.
The 5-way push-button (6) for menu control now has the following functions:
–
or
= Select character
–
or
= Confirm character/entry
–
= Finish entry
The "DEL" field is used to delete a character, and "OK" is used to save the current entry.
After making changes to the current name without saving them with "OK", a confirmation prompt pops up
on the screen when pressing
"CANCEL" (abort). Press
Proceed with the next setting as described. Press
or
to confirm your selection.
or
to go one menu level back or exit the submenu/setup menu.
to finish the entry. Use
to confirm the selection.
to go one menu level back or exit the submenu/setup menu.
to toggle between
to confirm the selec-
or
to toggle between "OK" (save name) and
Figure 41
Figure 42
Figure 43
69