VOGEL KFA Serie Bedienungsanleitung Seite 78

7. Programming
•
Programming always starts with
steps 1 and 2!
•
You can see from the flashing of the LED
indicators that the programming mode is
active.
7.1 Starting the programming
mode
7.2 Changing the lubrication
interval times
Carry out steps 1 and 2!
Note concerning step 2:
If the manufacturer's code 000 has already been
changed, you have to select the new code with
keys and confirm it with key
Step
1
Press for more than 2s
2
Press briefly
(confirm code)
3
Press briefly
4
5
Press briefly
(confirm new value)
.
6
Press briefly
7
8
9
Key
Press briefly Confirm new value
Press for
Changes are written to the memory, and the LED indicators
more than 2s
extinguish.
Page 29
Contents Chapter
7
Operating Instructions KFA, KFAS
Display
000 in display flashes
(code 000 factory setting)
Automatically indicates first parameter
Example: „Pause in timer operation"
LED „Pause" flashes
Pause time 1 h (factory setting)
For permissible setting range for
KFA/KFAS, s. Technical data - Operating
mode, section 9
Set new value
Example: 6.8 h = 6 h 48 min
Indicates next parameter
„Pump running time in timer mode"
LED „Contact" flashes
Pump running time 4 min (factory setting)
For permissible setting range for
KFA/KFAS, s. Technical data – Operating
mode, section 9
Set new value
Example: 3 min