SOMFY animeo 1860105 Gebrauchsanweisung Seite 7

EN
A
PICTURES
[1] animeo RTS Receiver 433 MHz (Ref. 1860105)
B
MOUNTING
[1] Switch off voltage supply
Remove the cover of the animeo Motor Controller.
Place the animeo RTS radio module.
Switch on voltage supply.
The LED's shine according to picture.
C
CONFIGURATION/STATUS INDICATION
Notes:
• Several RTS radio modules should not be programmed
at the same time.
• Max. 20 channels can be stored per RTS radio module.
• The learning readiness ends automatically after
60 seconds if no input takes place.
[1] Train the first sender
Press PROG button on Motor Controller for approx.
2 seconds. Green LED lights up, the drives confirm
with short up or down movement. Briefly operate
the PROG button of the trained sender. Green LED
goes out, the motors confirm with short up/down
movement.
[2] Modify the allocation of the motor outputs
Press PROG button of a sender already trained for
2 seconds. Motors confirm with short up or down
movement. Switching between the individual motors
by means of up or down button. Motor confirms
with short up or down movement. Press STOP button
briefly in order to confirm or delete the allocation of
the selected motor.
1. Delete: Motor confirms with short up or down
movement.
2. Confirm: Motor confirms with short up/down
movement. Press PROG button briefly, motor confirms
briefly with up or down movement.
Allocation completed.
Somfy hereby declares that the radio equipment covered by these instructions is in compliance with the requirements of Radio Directive 2014/53/EU
and the other essential requirements of the applicable European Directives.
The full text of the EU declaration of conformity is available at www.somfy.com/ce.
[3] Train further sender
Press PROG button at the trained sender
Motor Controller 2 for 2 seconds. Green LED lights up,
the motors confirm with short up or down move-
ment. Briefly operate the PROG button of the trained
sender. Green LED goes out, the motors confirm with
short up/down movement.
[4] Delete the sender
If the teach-in process is repeated with an already
trained hand sender, then this is erased.
m 1 remote remains trained and cannot be deleted.
[5] Training intermediate position (IP)
Move motors to the desired position and stop posi-
tions. Press STOP button for 2 seconds. Motor confirms
with short up/down movement. Intermediate position
is stored.
[6] Calling intermediate position (IP)
The motor is not in motion. Press STOP button shortly
(0,5 seconds). Motor moves to the stored intermediate
position (IP).
[7] Erase intermediate position (IP)
Motor moves to the stored intermediate position (IP).
Press STOP button for 10 seconds. Motor confirms with
short up or down movement.
[8] Reset into delivery status
Press PROG button on Motor Controller for 5 seconds.
Green LED lights up briefly, all motors confirm with
short up/down movement. RTS radio module is again
on delivery status.
m If the PROG button of the Motor Controller is
kept pressed for longer than 10 seconds, the Motor
Controller will be also reset!
animeo RTS Receiver . REF. 5012562E -
1
or at the
7/16