Aycorn AY-L1-10-UK Bedienungsanleitung Seite 5

Step 3: Insert the lock into the applicator provided.
Step 4: Clip the catch face down into the top of the applicator.
Step 5: Remove the film from the adhesive on the back of the lock and the back
of the catch.
8 | English
Step 6: Firmly press the side with the catch to the inside of the cabinet. Ensure
that when the door closes, the side with the lock will stick to the door. For overlay
cabinets ensure that it is flush to the edge so that the locks stick to the inside of
the cabinet door. For inset cabinets, begin by measuring the thickness of your
door. Ensure the catch is placed this measurement away from the edge so that
the cabinet door will be able to close properly.
Inset Cabinets: Door width
measurement gap
Step 7: Open the door. The lock should be attached to the inside of the door. If
the lock is not attached to the door, the catch and applicator were placed too
far back inside the cabinet. Move the catch closer to the edge of the cabinet.
2
Overlay Cabinets: Flush to
the edge
English | 9