Godox V1C Benutzerhandbuch Seite 17

1. Focus the subject
2. Press the <FEL> button.
Aim the subject at the center of the viewfinder and press <FEL> button.
•
The camera flash will fire a preflash and the required flash output for the subject
•
in retained in memory.
Each time the <FEL> button is pressed, a preflash will be fired and a new flash
•
exposure setting will be locked.
If the subject is too far away and underexposure, the < > icon will blink in the
•
viewfinder. Move closer to the subject and try the FE lock again.
If <ETTL> is not displayed on the LCD panel, FE lock cannot be set.
•
If the subject is too small, FE lock might not be very effective.
•
High-Speed Sync
High Speed Sync (FP flash) enables the flash to synchronize with all camera shutter
speeds. This is convenient when you want to use aperture priority for fill-flash portraits.
Press Function Button 2 <SYNC> so that
< > is displayed.
If you set a shutter speed that is the same as or slower than the camera's
•
maximum flash sync speed, <
With high-speed sync, the faster the shutter speed the shorter the effective flash
•
range.
To return to normal flash, press <SYNC> button again. Then <
•
Multi flash mode cannot be set in high-speed sync mode.
•
Over-temperature protection may be activated after 15 consecutive high-speed
•
sync flashes.
Check that <
viewfinder.
> will not be displayed in the viewfinder.
17
> is displayed in the
> will disappear.