Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.
Remote Control Overview
Refer to illustration [B2] on page 3 of this manual.
1
length, dimming and speed setting
2
length of the illuminated section
3
8 constant colours
4
3 colours simultaneously
5
7 colours simultaneously
6
16 colours simultaneously
7
different chase effects
8
shooting stars effect from left to right
9
automatic colour change, fast
10
automatic colour change, slow
11
smooth cycle effect
12
automatic run through all the programmes
13
on/off
14
warm/cold white
6.
Installation
Guidelines
Avoid installing the LED strips near heat sources such as ovens,
toasters, etc.
Never use the LED strip when it is coiled up as this can cause
overheating.
Before mounting, ensure the desired surface is flat and clean of
any grease, dirt or debris.
Avoid tight bends in the LED strip.
Observe the correct polarity when re-joining cable sections. The
polarity is marked at regular intervals along the LED strip.
Cut the strip using sharp scissors or a craft knife with a fresh
blade. Cut directly on the marked line. Never cut the LED strip
when it is plugged in.
Installation
Refer to the illustrations on page 2 of this manual.
1.
Mount the LED strip in the desired location. The LED strip can be
cut every 10 cm (see [A1]). Protect the cut ends to avoid short-
circuits.
V. 01 – 30/07/2014
LEDS10DRGB
6
©Velleman nv
Werbung
