AUTO-HAK O06 Bedienungsanleitung Seite 4

FITTING INSTRUCTION
Clamp mark
in acc. with Cables joining
ISO PN
1 L Left directional lights
2 + Rear fog lights
3 31 Ground
4 R Right directional lights
5 58R Right side parking lights
6 54 Stoplights
7 58L Left side parking lights
M10x60mm
A
5
14
M10x60mm
14
9
15
4
M8x40mm
M8x40mm
14
M10x40mm
This towbar is designed to assembly in following car:
TOYOTA COROLLA, 3 door, E 11, produced since 07.1997 till 07.2001,
catalogue number O06 and is prepared to tow trailers max total weight
1200 kg and max vertical mass 75 kg.
Thank you for buying our product. Their reliability has been confirmed in
many tests. Reliability of towbar depends also on correct assembly and right
operation. For this reasons we kindly ask to read carefully this instruction and
apply to hints.
The towbar should be install in points described by a car producer.
A
5
14
M10x30mm
14
1
6
2
3
Figure 1
From manufacturer
1. Disassemble a rear bumper.
4
2. Disassemble metal protective covers from chassis members.
3. Through original holes in chassis members put bolts M10x60mm (pos.
15
7) together with distance sleeves ø25x6, L=31mm (pos.5) as shown in
the figure 1.
M8x40mm
4. Carefully put main bar of the towbar (pos. 1) to chassis members in this
way so distance sleeves stay on right place and put bolt M10x60mm
through holes pos. A and fix loosely.
M8x30mm
5. In rest places of fastening fix towbar using bolts from equipment
according to figure 1.
14
6. Reassemble the bumper after cut off elements as shown in the figure 2.
M10x40mm
7. Fix tow-ball (pos. 2) and socket plate (pos. 3) by bolts M12x75mm (pos.
M8x40mm
6) from equipment.
8. Fix tight all bolts according to the torque shown in the table.
9. Connect electric wires of 7-poles socket according to the instruction of
the car. (Recommend to make at authorized service station)
10. Complete paint layer damaged during installation.
After install the towbar you should get adequate note in registration book (at
authorised service station).The car should be equipped with:
•
Indicators
•
Tow mirrors
After 1000km check all bolts and nuts. The ball of towbar must be always kept
clear and conserve with a grease.
The instruction of the assembly
Figure 2
Torque settings for nuts and bolts (8,8):
M 8 - 25 Nm M 10 - 55 Nm
M 12 - 85 Nm M 14 - 135 Nm
NOTE
Cut off