Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The installation should only be performed by those with knowledge of electrical wiring. If unsure,
contact a qualified electrician. Carefully read the instructions before the installation.
Caution! Closely check that the power is shut off before starting the installation.
1. Fasten the ceiling light onto the ceiling in
an appropriately secure manner.
Use the included screws.
2. For ceilings made of concrete or similar
material: Use the light fixture's base as
a template and mark out where the desired
mounting holes are to be drilled. Drill two
6 mm mounting holes, insert anchor plugs
into the holes and use the included screws
for mounting the light fixture securely onto
the ceiling. Watch out for hidden pipes or
electrical wiring.
3. Thread the included wire insulators (h) over
the incoming mains electrical wires. Then
connect these wires to the terminal block (g)
according to the wiring diagram.
4. Screw in a light bulb (max 60 W, E27).
5. Unscrew one of the diffuser's retainers (f).
Mount the glass diffuser. Refit the screw
and tighten, ensuring that the diffuser sits
securely in place.
Care and maintenance
•
Switch off the power to the ceiling light before cleaning.
•
Clean the light using a soft, damp cloth. Use a mild detergent. Never use solvents or strong,
abrasive cleaning agents. These could possibly damage the product.
Disposal
This product should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local council.
Specifications
Max bulb wattage
60 W, E27 (sold separately)
Input voltage
220–240 V AC, 50 Hz
31 cm
Diam
Class 1, IP20 (this light fitting must be earthed)
Ceiling cable
N
L
N
L
Wires to the light source
6
Connection block
= Earth (Yellow-Green)
L =
Live (Brown)
N =
Neutral (Blue)
Werbung
