Troubleshooting Guide - CO/Tech MDT1-10DMN3-QA3-UK Bedienungsanleitung

Troubleshooting guide

The dehumidifier will
not switch on.
The humidity is
not reducing.
Unusual noises emitted
during use.
The dehumidifier is
leaking.
The POWER LED
flashes.
Disposal
This dehumidifier should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local authority.
• Make sure that the mains lead is properly plugged
in and that there is power in the wall socket.
• The water reservoir is full or incorrectly fitted.
• The dehumidifier has not been used long enough.
• Make sure that nothing is preventing the air in
the room where the dehumidifier is used from
circulating properly.
• Make sure that no outdoor air can enter the room
in which the dehumidifier is being used.
• The ambient temperature is below 15 ºC.
• Is there a heat source in the room which is raising
the humidity?
• Make sure that the air filter is clean.
• The dehumidifier is tilted or standing on an
uneven surface.
• Make sure that the drain hose is properly connected
if the dehumidifier is used in continuous
operation mode.
• Make sure that the rubber plug is covering the drain
hose connection if the dehumidifier is used in normal
mode/not continuously.
• The humidity and/or temperature sensor is
defective. Turn off the air conditioner, pull out
the plug and plug it in again. If this does not solve
the problem, contact a qualified service centre.
8