Whirlpool WBE 2212 NFW Gebrauchsanweisung Seite 20

INSTALLATION
• Install the appliance away from heat sources. Installation in a hot environment, direct exposure to the sun
or installation near heat sources (heaters, radiators, cookers) will increase power consumption and should
therefore be avoided.
• If this is not possible, the following minimum distances must be respected:
- 30 cm from coal or oil-fired cookers;
- 3 cm from electric and/or gas cookers.
• Fit the spacers (if supplied) on the rear of the condenser positioned at the back of the appliance (see
figure).
• To optimise appliance efficiency, leave a 5 cm gap above the appliance and make sure that adjacent kitchen
units are sufficiently distanced to allow air circulation.
• Install the appliance in a dry, well-ventilated place, and ensure it is level, using the front adjustment feet if
necessary.
• Clean the interior.
• Fit the accessories.
Electrical disconnection
• Electrical disconnection must be possible either by unplugging the appliance or using a double-pole switch
located upline from the socket.
20