Fujitsu ScanSnap fi-5110EOX Los Geht's Seite 22

6. Remove the Pick roller from the shaft.
Pull out the shaft from the Pick roller while lifting up
its tab.
Tab
If you push up the pick roller tab using your
ATTENTION
fingernail, it may heart or get chipped your
fingernail. If you worry about that, you push up
the pick roller tab using a paper clip.
7. Attach the new Pick roller to the shaft.
Insert the new Pick roller aligning the protrusion with
the slot on the Pick roller.
Shaft
8. Install the Pick roller with its shaft into the scanner.
and set the shaft to the slot while lowering it.
Shaft
18 |
Shaft
Pick roller
1
2
Pick roller
Groove
Protrusion
Bushing
Pick roller
9. Fix the Pick roller bushing (left) by rotating it in the
direction of the arrow.
Pick roller bushing
Pick roller
Make sure that the Pick roller is
ATTENTION
completely attached and correctly
installed. Otherwise, document jams or
other feeding errors may occur.
10. Attach the sheet guide to the scanner.
While holding the handle on the sheet guide, set the sheet
guide into the scanner.
Sheet guide
You should hear the sheet guide click when it
returns to its original position.
11. Close the ADF.
ADF cover
You should hear the ADF cover click when it
returns to its original position.
12. Turn on the scanner.
ScanSnap Manager icon changes from
Shaft
Handle
Craw
S
to .