Basic Use - Alzatools At-Ccs20V Bedienungsanleitung

BASIC USE

SWITCH
The switch can only be pressed at the same time as the safety catch to prevent the saw from acciden-
tally starting.
• To start the saw, first, hold the lock and then press the switch.
DUST EXTRACTION
Inhaling cutting dust can adversely affect your health. Therefore connect a suitable extractor (vacuum
cleaner) to the machine outlet.
Note: A tube diameter adapter may be required for connection.
Warning: All wood dust (including laminate dust, plastics dust, etc.) poses a health risk to the
respiratory system, eyesight and skin. For example, MDF boards contain formaldehyde, which is
a proven carcinogen. In addition to the above measures, we recommend the use of a suitable face
mask according to the scope of work. A respirator of at least FFP2 is required against fine wood dust.
CUTTING DEPTH ADJUSTMENT
• To adjust the depth of the cut, first release the depth of cut adjustment lever.
• Set the required depth; use the depth scale for orientation.
Note: You can achieve a more precise setting by measuring the distance of the tooth tip from the
saw base plate.
• After adjustment, tighten the depth adjustment lever again.
CUTTING ANGLE ADJUSTMENT
To change the cutting angle between 0° and 45°, loosen the cutting angle adjustment screw.
Note: The scale is for guidance only. For precise adjustment, the angle of the blade relative to the
saw base plate must be measured.
• After adjusting, retighten the cutting angle adjustment screw.
SIDE GUIDE
• Insert the side guide through the hole in the base and secure it with the guide adjustment screw.
• Set the required guide distance (cutting width); use the scale on the guide for orientation.
• Make a test cut on the rest of the material and adjust the guide more accurately if necessary.
• For more accurate measurement, measure the distance from the guide face to the tooth flank.
14 ENGLISH