Operating Determinations - EuroLite LED Neon Flex230V EC Bedienungsanleitung

Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or problems.
Never hit the lighting chain with a hammer or other tools, as this may lead to damaged lamps.
Never operate the device in the packaging or wrapped in order to avoid heating-up.
Never let the power cord come into contact with other cables! Handle the power cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the technical sticker.
Make sure that the power cord is never crimped or damaged by sharp edges. Check the device and the
power cord from time to time.
This device falls under protection-class II and features a protective insulation.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power
cord by the plug. Never pull out the plug by tugging the power cord.
If there are reasons for supposing that risk-free operation is no longer possible, the lighting chain must be
deactivated and protected against accidental operation. Risk-free operation can no longer be supposed
when the lighting chain
• no longer functions
• is visibly damaged
• has been stored long-term under adverse conditions, or
• has been exposed to stress during transport.
Caution: During the operation, the lighting chain can heat up.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a lighting chain for creating decorative effects. For operating the lighting chain with 230 V, 50
Hz direct current, the optional power adpater cord is needed. The adapter cord is allowed to be operated
with an alternating voltage of 230 V, 50 Hz and can be loaded with 900 W maximum.
The lighting chain is splash-proof (IP 44) and therefore qualified for indoor and outdoor use. For outdoor use,
the installer must always make sure to connect a rubber cable HO5RR-F. All valid instructions concerning
the installation of cables outdoors or in the ground must be adhered! The ambient temperature must always
be between -10° C and +45° C. Keep away from direct insulation (particularly in cars) and heaters. The
maximum relative humidity is 100 % with an ambient temperature of 25° C. This device must only be
operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
This lighting effect may not be connected to dimming packs!
11/16 00046328.DOC, Version 1.1