Werbung
Verfügbare Sprachen
Verfügbare Sprachen
26131L
Note:
A crankshaft pulley requiring the T10050 has its
timing mark aligned with a tooth where as a pulley requiring
the T10100, the timing mark is between the teeth.
Tool 1 allows the user to adjust the Camshaft
drive belt tensioner pulley.
Tool 2 is used to lock the tensioner in the retracted
position to make belt removal and fitting easier.
Tool 8 is used to lock the auxiliary belt tensioner in its retracted position.
Tool 3 the sprocket holding tool allows the user to hold the appropriate sprocket whilst
loosening its fixing without damaging the locking pins.
Tool 4 is a Camshaft hub puller and is required when dismantling the upper cylinder
head. It is used to remove the Cam to Cam gears so they can be timed to each other
correctly.
Tool 7 is for removing and installing the balance shaft module
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Strasse 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
Werbung
