Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The appliance can be used with any gas cylinder of weights between 4.5 kg and 15 kg butane
and 3.9 kg and 13 kg propane. The gas cylinder should not be dropped or handled roughly! If
the appliance is not in use, the cylinder must be disconnected. Replace the protective cap on
the cylinder after disconnecting the cylinder from the appliance.
Cylinders must be stored outdoors in an upright position and out of the reach of children. The
cylinder must never be stored where temperatures can reach over 50°C.
Do not store the cylinder near flames, pilot lights or other sources of ignition. DO NOT SMOKE.
CLEANING AND CARE
CAUTION: All cleaning and maintenance should be carried out when the barbecue is cool and
with the fuel supply turned "OFF" at the gas cylinder.
CLEANING
"Burning off" the barbecue after every use (for approx. 15 minutes) will keep excessive food
residue to a minimum.
OUTSIDE SURFACE
Use mild detergent or baking soda and a hot water solution. Non-abrasive scouring powder
can be used on stubborn stains, then rinsed with water.
If the inside surface of the barbecue lid has the appearance of pealing paint, it means that
baked-on grease build-up has turned to carbon and is flaking off. Clean thoroughly with a
strong hot soapy water solution. Rinse with water and allow to completely dry.
NEVER USE
OVEN CLEANER
INTERIOR OF BARBECUE BOTTOM
Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water
solution. Rinse with water and allow to dry.
PLASTIC SURFACES
Wash with a soft cloth and a hot soapy water solution. Rinse with water. Do not use abrasive
cleaners, degreasers or a concentrated barbecue cleaner on plastic parts.
COOKING GRID
Use a mild soapy water solution. Non-abrasive scouring powder can be used on stubborn
stains, then rinsed with water.
GREASE TRAY AND GREASE CUP
Do not open the grease tray during use.
When cleaning the grease tray, pull out the grease cup first and then the grease tray.
Check the grease cup from time to time and drain the oil when 1/3 full.
Method: After the grease cup has cooled, shake it horizontally in an up and down motion with
the hook pointing down. This should remove the grease from the cup.
CLEANING THE BURNER ASSEMBLY
23
Werbung
Inhaltsverzeichnis
