Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTRUCTIONS FOR USE
Please follow these instructions carefully. Failure to do so could result in serious damage to
your barbecue as well as injury to you and your property.
1. Assemble the barbecue following the assembly instructions carefully.
2. Connect the gas hose to the barbecue. Connect the regulator to the hose.
3. Connect the regulator to the cylinder valve following the regulator instructions supplied with
the regulator.
4. Turn all of the control knobs to the "OFF" position before turning on the gas supply to the
appliance.
5. Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING YOUR BARBECUE
Lighting Instructions: Main Burners
1. Connect the gas cylinder to the barbecue following the instructions supplied with the
regulator.
2. Turn all the control knobs to the "OFF" position.
3. Turn "ON" the gas supply at the cylinder or regulator switch following the regulator
connection and operating instructions. Check for leakage at the cylinder to regulator
connection and hose to barbecue hose inlet connection using soapy water. Any leakage
will appear as bubbles in the area of the leak. If a leak is found, do not use the barbecue.
Contact your gas or barbecue supplier for advice.
4. To light the left-hand burner, push down and turn the left burner control knob anti-clockwise
to the 90° position (full rate position). An audible click will be heard; this should light the
burner. Check that the burner is correctly lit. If the burner has not lit, repeat this process.
5. If the burner has not lit after two attempts, turn "OFF" the gas tap and wait 5 minutes before
retrying the ignition sequence.
6. When the burner has lit, the burner rate can be adjusted by turning the knob anti-clockwise
to any position between the full and low rate positions.
7. To light the middle burner, push down and turn the middle burner control knob anti-
clockwise to the 90° position (full rate position). An audible click will be heard; this should
light the burner. Check that the burner is correctly lit. If the burner has not lit, repeat this
process.
8. If the burner has not lit after two attempts, turn "OFF" the gas tap and wait 5 minutes before
retrying the ignition sequence.
9. When the burner has lit, the burner rate can be adjusted by turning the knob anti-clockwise
to any position between the full and low rate positions.
10. To light the right-hand burner, push down and turn the right-hand burner control knob anti-
clockwise to the 90° position (full rate position). An audible click will be heard; this should
light the burner. Check that the burner is correctly lit. If the burner has not lit, repeat this
process.
11. When the burner has lit, the burner rate can be adjusted by turning the knob anti-clockwise
to any position between the full and low rate positions.
20
Werbung
Inhaltsverzeichnis
