Siemens S1 RKM 09002 Gebrauchsanweisung Seite 21

Instructions for Use
Temperature
control
Plug your appliance in.
Lead the hot-air expulsion duct outdoors.
Set to maximum
control.
Turn the drainage stopcock to the cooling
position.
Set the thermostat to the desired temperature.
Should the appliance turn itself off by thermostat,
it will not come back on again until room
temperature goes up 2-3°C.
The appliance lowers the temperature and dries
the air in the room at the same time in order to
create ideal air conditions.
Condensed water formed during air conditioning
evaporates automatically and is expelled outdoors,
together with hot air, through the hot-air expulsion
duct. In conditions of extreme humidity, the
appliance accumulates water in an internal tank.
When the water in this tank reaches a certain level,
safety pilot light comes on, indicating that the tank
needs to be emptied.
Turn the appliance off and wait 10 minutes for
the safety systems to reset.
Turn drainage stopcock 90 ° in an anti-clockwise
direction.
Remove the plug from stopcock 10 and insert
drainage pipe.
Place a bowl at the drainage pipe outlet to
collect the condensed water in.
Set the appliance to either the temperature
control or dehumidification position.
Warning!
Do not forget to put the plug back in place on
the drainage stopcock and to turn the stopcock
90° in a clockwise direction before setting the
appliance to the temperature control setting.
The appliance will shed water if you fail to do
so.
You have now removed all the excess water
from the system and can turn the appliance
back on and use as normal.
or silent temperature
21