If you need to adjust the angle of the doorbell, you can use the wedge
provided. (The Reolink Video Doorbell PoE is taken as an example)
Step 1 Put the mounting hole template on the wall and drill holes as shown.
Step 2 Install the wedge using the screws provided through the two holes.
Ensure that the notched side of the wedge is facing outside.
Step 3 Screw the mounting plate to the wedge.
Step 4 Run the Ethernet cable through the wedge and mounting plate, and
attach the doorbell to the plate.
Notched Side Facing Doorbell
15
English
Remove the Doorbell
If you want to remove the Doorbell from the mounting plate, you may
use the reset needle to poke the bottom.
1
1
2
2
English
16