Computer Instructions - Energetics ST 880 Bedienungsanleitung

SUMMARY:
This system is designed for programmable ROWING MACHINE. There are 3 parts to this System the monitor,
motor & controller and magnetic braking system.
A. Power up:
B. KEY BOARD:
ENTER:
START/PAUSE/RESET:
⊕ ▲:
○, - ▼:
PULSE RECOVERY

Computer instructions

a. Connect all of the cables to the monitor.
b. After power up, all LCD segments will light up for 2seconds and CPU Will be
reset the resistance into level1. The monitor will go to initial mode.
1. If the connection cables were installed incorrectly, monitor will display
"E1"on matrix display and generate a beep sound. Before asking service,
please examine if all connection cables are well connected and then reset
the power to release the beep sound or press "START/PAUSE (Hold to
reset)"button to restart system. If the monitor still show"E1"message,
please call service.
2. If the monitor shows"E2"message, please call service.
1. During PAUSE mode, press ENTER key to enter desired program.
2. Confirm the setting values of TIME, COUNT, DISTANCE, CALORLES and PULSE in
the heart rate control program8, and PROGRAM PROFILE in the user setting
program.
1. To start or pause exercising.
2. Hold this button for 2 secondes can enter initial mode & reset all value to zero.
1. During the pause mode, select Program or increase the setting value of TIME,
COUNT, DISTANCE, CALORIES and PULES in the heart rate control program 8,and
PROGRAM PROFILE in the User setting program.
2. During the exercise mode, press this button to increase the load level.
1. During the pause mode, select Program or decrease the setting value of TIME,
COUNT, DISTANCE, CALORIES and PULES in the heart rate control program 8,and
PROGRAM PROFILE in the User setting program.
2. During the exercise mode, press this button to decrease the load level.
Press this button going into pulse recovery detecting.
F1.0=Excellent F2.0=Good F3.0=Fair F4.0= below average F5.0=no good F6.0=Poor
9