Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USING THE TFT MONITOR
Open/Close TFT Monitor
Open TFT Monitor
Press the OPEN button (1) on the front panel or press the (
panel into the viewing position.
Close TFT Monitor
Press the OPEN button (1) on the front panel or press the (
ment.
TFT Monitor Auto Open
If "TFT Auto Open" is "on" when the unit is turned on, the monitor automatically moves to the viewing position.
If "TFT Auto Open" is "off" when the unit is turned on, press the OPEN button (1) or (
control to move the monitor into the viewing position.
If "TFT Auto Open" is set to "Manual", the TFT will not close when the key is turned off.
Monitor Tilt Angle Adjustment
A known characteristic of LCD panels is the quality of the display in relationship to the viewing angle. The monitor angle can be adjusted for opti-
mum viewing using one of the following methods:
Press the Tilt buttom to activate the Tilt function (a yellow symbol appear at the right top corner of the screen).
Step by Step Angle Adjustment
v
^ ^
Press the (
) or (
) button on the remote control to adjust the tilt angle of the screen one step at a time.
v
Press the TILT button (5) on the unit. While the blue tilt icon is flashing, turn the rotary encoder to adjust the screen angle.
Continuous Angle Adjustment
v
^ ^
Press and hold the ( ) or ( ) button on the remote control to adjust the tilt angle in a continuous motion.
v
Aspect Ratio
Press the WIDE button (28) on the remote control or WIDE/NAV button (4) on the monitor to adjust the aspect ratio as follows:
Playing Source
Radio
Disc
USB 1
USB 2
SD
BT
NAV
AUX
CAMERA
) button (25) on the remote control to activate the mechanism that moves the display
FULL
The entire screen is extended horizontally to the aspect ratio of
16 to 9. The extension ratio is the same at any point.
NORMAL
The conventional display image has a 4 to 3 ratio of horizontal to vertical,
leaving a blank area on the right and left sides of the display.
STANDBY
Screen becomes black. Touch screen to resume.
Video Output Modes
RGB-Modus
RGB-Modus
CVBS-Modus
CVBS-Modus
CVBS-Modus
CVBS-Modus
CVBS-Modus
CVBS-Modus
CVBS-Modus
) button (25) on the remote control to load the display panel back into the compart-
) button (25) on the remote
Parameter Adjustment Procedure
1. Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the button (2) on the
monitor.
2. Select Item to Set:
Press the AUDIO button (5) on the control panel to select
"BRIGHT" or "CONTRAST".
3. Set Parameters:
Press the +/– buttons (15, 16) on the remote or turn the rotary encoder
(5) on the control panel.
4. Exit Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the button (2) on the
monitor
* CVBS - Composite Video Baseband Signal
12
Werbung
