Lavor EDP 5000 Gebrauchsanleitung Seite 12

Check that the pump is standing firmly on
n
the bottom.
DE
•
Before installing or moving the
pump always remove the mains
plug from the wall socket.
Switching on and off (fig. A)
•
Always check that the power
supply corresponds to the voltage
on the rating plate.
To switch on the pump, insert the mains
n
plug in the wall socket.
To switch off the pump, remove the mains
n
plug from the wall socket.
The pump only operates when the float
switch (1) floats. This prevents the pump
from running dry during operation.
•
The pump has been fitted with
a thermal protection. In case of
overload the motor is switched off.
After the motor has cooled down
the pump automatically switches
on again.
CLEANING AND MAINTENANCE
The pump is maintenance free. Defects
must only be repaired by an authorised
service station.
•
The pump must not be opened by
the user.
IMPORTANT (FOR UK ONLY)
If the moulded 3 pin plug attached to this
unit is damaged and needs replacing, it
is important that it is correctly destroyed
and replaced by an approved BS 1363/5A
fused plug and that the following wiring
instructions are followed.
The wires in this mains lead are coloured in
accordance with the following code:
blue neutral
brown live
green and yellow earth
12
As the colours of the wires in the mains
lead of this unit may not correspond to the
coloured markings identifying the terminals
in your plug, proceed as follows:
The wire which is coloured blue must
n
be connected to the terminal which is
marked with the letter N or coloured
black.
The wire which is coloured brown must
n
be connected to the terminal which is
marked with the letter L or coloured red.
The wire which is coloured green and
n
yellow must be connected to the terminal
which is marked with the letter E or
coloured green.