urmet 1092/221M Bedienungsanleitung Seite 16

INSTALLATION
1 Make sure that no units are powered before starting the installation procedure.
2 Install the camera on the bracket and fasten it.
3 Position the bracket to frame the required picture and fasten it to the wall or other flat surface.
4 Connect the video output to the utility.
5 Power the camera.
6 Adjust the lens to frame the required images.
•
Remove the camera top.
•
Loosen the protective dome.
•
Turn towards WIDE "W" to move the subject away (the frame and angle become consequently
wider).
•
Turn towards TELE "T" to move the subject closer (the frame and angle become consequently
narrower).
•
Turn towards NEAR "N" to adjust focus of nearby subjects.
•
Turn towards FAR "∞" to adjust focus of faraway subjects.
Focus adjustment ring
VARIFOCAL adjustment ring
OPERATING FEATURES
The camera may be operated only using the UTC controls available on the DVR/HDVR of the Urmet
catalogue implementing the function. Refer to the complete product documentation on the Urmet website to
check for the list of available devices.
These controls can be used to access the OSD menu.
Refer to the respective product manuals for using the controls.
MENU USE
The camera ref. 1092/221M uses a multi-level menu that allows to enable/disable or change camera
settings.
MENUS SYSTEM DESCRIPTION
Once the menu access command has been performed, the access first screen will be displayed.
Once the item has been selected, the parameter can be changed choosing among the available options.
By selecting the item associated to the symbols
where other changes can be performed.
To quit the menu or the submenu and confirm the executed changes, select the item EXIT→ SAVE&END
and press the central button.
To reactivate the default values select the item EXIT→ RESET and press the central button.
16
Blind spot covered
by LEDs
or
Focus adjustment ring lock
pin
VARIFOCAL adjustment ring
lock pin
it is possible to access to the next submenu,
DS1092-542B