Trust START-LINE ACDB-8000AC Bedienungsanleitung Seite 9

B
Determine where the push button will be placed and
secure the back plate with the supplied screws.
C
Place the push button back on the back plate by sliding
it from top to bottom.
Changing the battery of the push button
A
When the battery is low, the LED will light up for 2 sec
and then blink 3 times after pressing the push button.
Insert a flat screwdriver into the notch on the bottom
of the push-button and slide the push-button off the
back plate.
B
Open the waterproof rubber to reveal the battery
C
Remove the old battery and insert a new CR2032
battery into the recess of the battery holder. Make sure
the + is pointing upwards.
C
Close the waterproof rubber and place the push button
back on the back plate.
Unpair a Trust Smart Home transmitter
A
Press the connect button for 1 second. The learning
mode will be active for 10 seconds and the LED indicator
on the receiver will blink slowly.
B
While the learning mode is active, send an ON signal
with the channel of the paired Trust Smart Home
transmitter you want to disconnect
C
To confirm, the wireless doorbell will give 2 short beeps.
Erasing the entire memory
A
Press the connect button (8 seconds) until the LED
indicator starts flashing rapidly. The erase mode will
be active for 10 seconds and the LED indicator on the
receiver will flash rapidly.
B
While the delete mode is active, press the learn button
again for 1 second to confirm that you want to delete
the memory completely.
ACDB-8000AC PLUG-IN WIRELESS DOORBELL SET
C
To confirm, the wireless doorbell give 2 short beeps
Combine the push button with the ICS-2000/
Smart Bridge
Combine the push button with the ICS-2000/Smart Bridge
and also receive a push notification on your smartphone
when the doorbell rings.
For example, you can turn the wireless plug-in doorbell
off at night and only receive a push notification when the
push button is pressed.
EN
9