Rebel URZ3490 Bedienungsanleitung Seite 6

SAFETY INSTRUCTIONS
Please read this operation instruction carefully before first use, and
keep it for future reference. If there are any doubts concerning
correct installation, please consult a qualified specialist.
1. If the device or any of its part is damaged, do not use it and
unplug it from power source. Do not repair the device yourself.
Contact with an authorized service point for check-up/repair.
2. Prior to any maintenance services, disconnect power supply
and let the device cool down.
3. Do not cover the device.
4. WARNING: Do not look directly at LED light beam!
5. Clean the device with soft and dry cloth. Do not use chemical
detergents.
6. Failure to follow these instructions may result in fire, burns,
electrical shock, physical injury and other damage.
7. WARNING: Device may heat up to a higher temperature. Do not
touch the device when it's hot.
8. Before connecting the device to power supply socket, make
sure the voltage indicated on the appliance corresponds to the
voltage in the power supply socket.
FEATURES
• Device belongs to the group of energy efficient products.
• Minimal distance of a light fixture (its light source) from the spots
and objects that it's illuminating - 0,5 m.
• This device is build in a way that it is impossible to open it. Repair
by user is not allowed.
EN
10
MOUNTING
Read the manual before mounting. Mounting should be performed
by an appropriately qualified person. Check for proper mechanical
fastening and connection to electrical power prior to first use.
1. Remove the mounting bracket from the Led floodlight. Drill the
wall and screw the bracket onto the wall using suitable plastic
wall plugs and screws. Check that the bracket is securely fitted
on the wall.
Note: Do not at this stage re-attach the floodlight to the bracket.
2. Connect the power cords:
• brown wire (ACL) of the floodlight with Live brown or red wire
of the electrical wiring;
• blue wire (ACN) of the floodlight with Neutral blue or black
wire of the electrical wiring;
• yellow-green wire of the floodlight with earth wire of the
electrical wiring.
3. Re-attach the floodlight to the bracket and secure the cable to
the wall using suitable clips. Ensure that the cable is not
touching the body of the floodlight, and that there is sufficient
slack in the cable to allow the floodlight to be tilted and
adjusted as required, which should be done by grasping the
metal body of the floodlight, not its rear wiring box.
11
EN