Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USER INSTRUCTIONS / FUNCTION
3. SET INSTRUMENT ON STAND
3.
- ADJUST SUPPORTS (c) -
NOTE:
3.6 Make sure that the bass trumpet is in
3.6
contact with both the upper and the
3.6
lower support.
3.7 If the supports are imbalanced,
3.7
the instrument could wobble.
3.7.1 DISTANCE too SMALL:
3.7.1
- the bell touches only on the bottom
3.7.1
- the instrument can wobble at the top
3.7.2 DISTANCE too LARGE:
3.7.2
- the bell touches only on the top
3.7.2
- the instrument can wobble at the bottom
4. TIPS FOR STAND SAFETY
The prerequisites for the stable footing
of the loaded stand are:
- a load-bearing and level surface,
- a properly set up stand
- a suitable instrument (bass trumpet/flugelhorn)
A favorable center of gravity can be achieved by:
4.1 - placing the instrument over one of the three feet
4.2 - positioning the extension tube:
4.2
- as high as necessary
4.2
- as low as possible
5. HEIGHT
- Minimum height: 480 mm
- Maximum height: 700 mm
- In between, the pull-out is infinitely
-
adjustable in any position
NOTE 1:
We recommend that you first remove the instrument,
set and fix the desired height, and then reattach the
instrument.
NOTE 2:
If the instrument (approx. 2 kg) is to remain on the stand,
make absolutely sure to hold the extension tube firmly
before loosening the clamping screw.
Uncontrolled retraction under load poses a hazard.
5.1 Hold pull-out
5.2 Loosen clamp-clamping screw b.2
5.3 Move the extension tube to the desired height
5.4 Re-tighten the clamping screw b.2
5.5 Reattach the instrument (see Chapter 3)
6. DIMENSIONS
MAINTAIN, CLEAN
- Always carry out maintenance in unloaded condition
- Regularly check:
-
a. proper condition of the components (defective
- a.
parts must be replaced or repaired)
-
b. Tight fit of all screw connections
- Pay attention to possible hazards during
-
maintenance work like bumping, overturning,
-
squeezing
- It is best to use a slightly damp cloth for
-
cleaning and use non-abrasive cleaning agent
FAULT-FINDING (F) and REPAIR (R)
F: Stand wobbles
F:
R: Check the surface or put it in order
F:
R: Ensure the completeness, functionality,
F: R:
and proper installation of the base frame
R: Re tighten screw connection
F: Instrument wobbles
F:
R: Ensure optimum spacing of end cap c.3 and
F: R:
the rubberized support c.2. Correct if necessary
TECHNICAL DATA
Tubes: Steel, powder coated black
Thread: Steel, galvanized
Material
Clamp: Zinc die-cast, powder coated, black
Base, socket handles: PA, black
Parquet protector, pad: TPE, black
Footprint: diameter 570 mm
Dimensions
Height: 480 - 700 mm
Weight
1.06 kg
Box
600 x 115 x 90 mm
Carrying case optional: K&M 10811-000-00, 10012-000-00
3. SET INSTRUMENT ON STAND
3.
- ADJUST SUPPORTS (c) -
Distance:
OK
4. TIPS FOR STAND SAFETY
Distance
too:
SMALL
5. HEIGHT
6. DIMENSIONS
Distance
too:
LARGE
Werbung
