Battery Care; Troubleshooting - zoopa Thunder 400 Anleitung

Binding
Controller and model are normally paired out of the box. If this is not the case or binding is lost, please
perform the following steps:
1.Connect the battery to the model.
2.Keep pressed the Bind- button on the boats receiver until the LED starts flashing.
3.Press the Bind- button on the controller before you switch it on.
4.After the controller has been activated, it will perform a beep sound as long as it is looking for a
signal. Once succesfully paired to the boat, the sound will stop.

Battery care

To ensure a long battery life, please follow these steps:
- Never store the model in activated mode, make sure it is switched off.
- Only store with charged battery (min. 85% capacity)
- Disconnect the battery from the model
- Store at room temperature
- When not using, make sure the battery will be charged every 3 months
If these steps are not being followed, the battery might get damaged.
Propeller replacement
You can replace the boats rotor in a few steps.
Unscrew the nut and pull off the rotor from the shaft. Mount the new rotor and fix it again with the nut.

Troubleshooting

Error
The model does not
react on the
commands
The model makes
strange sounds
The controller has no
connection to the
model
The model shows a
weak performance
You can contact us anytime if you have further problems!
Please find our details at the "Service & Support" section.
www.ACME-online.de
Source
Controller batteries are not
inserted correctly.
Batteries are empty
Model battery is empty
Blades/ Gears are
damaged
Weak battery
Controller batteries are
empty
Battery damaged
The model is out of range
The motor is worn out
ACME the game company
Solution
Check the battery
Replace the batteries
Charge the battery
Check these and replace them if needed
Charge the battery
Replace the batteries
Replace the battery
Check all motors and replace it if needed