Inserting The Battery - zoopa Thunder 400 Anleitung

www.ACME-online.de

Inserting the battery

Switch on the controller. The LED will light up in red permanently.
Please note, that the switch on the topside of the controller has to show „7:3". Always switch on the
controller before you operate the boat!
Once the battery is fully charged, you can connect it to the model. Remove the cover by pushing the
locker from „Close" to „Open". You got access on the connection cables now.
Check the polarity before you connect the battery to the model!
The boat will now release a beep- sound. Check the connection by turning the wheel on the controller
back and forth. If pairing was not successful, check the described progress in the controller section.
Place the battery and store the cables safely. Make sure that no cable blocks the inner electronics.
Close the cover. Make sure that you push the locker to „Close" again, and that no dirt gets inside the
seal.
Always switch on the controller before you connect the battery to the model!
When switching off, remove the battery at first and then switch off the controller.
Controller and boat are already paired out of the box.
ACME the game company