Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.2
LED
Colour
Meaning
L2
Yellow
File handling
(LED lights up)
L3
Green
Memory status
(LED is flashing)
Memory status
(LED lights up)
L4
Yellow
Warning status
(LED is flashing)
Warning status
(LED lights up)
Installing the firmware update
The PxtMX devices are delivered with firmware that matches the device type.
If a firmware update is to be carried out, the following steps are necessary:
Request an update file from Michael Koch GmbH.
The update file is provided on a micro SD memory card.
Insert the memory card into the micro SD slot of the device.
Press the BOOT button for longer than 5 seconds.
Operating display L2 lights up yellow.
The update process starts when the button is released and may take a few
minutes.
L2 lights up red briefly (start bootloader).
L1 and L3 light up long:
Valid firmware file (as long as L1 and L3 are lit, the firmware is being loaded).
L2 lights up blue:
The loading of the firmware is finished and the device has been restarted.
Operating display
Description
L1 (red) lights up.
The firmware update is loaded (this may take a few minutes).
L3 (green) lights up.
L3 (green) is flashing. Update successful.
After approx. 10 seconds, a restart of the device is initiated.
L2 (blue) lights up.
The device has been restarted after successful update and is
in operating mode.
L3 (green) lights up.
Error (no SD card or no content).
L4 (yellow) is flashing.
After approx. 10 seconds, a restart of the device is initiated.
Description
• Verify received file.
or
• Change to boot loader after pressing
the BOOT key > 5 seconds.
• Memory voltage >
UC_Start
• Memory voltage >
UC_Split
• Locked by digital input, CAN command
or field bus.
• At least one error message is present.
Operating manual Plug-on module PxtMX
6 Operation
25
V1.0DE/EN
Werbung
