Maintenance And Storage - YATO YT-85234 Originalanleitung

EN
Wear safety goggles and sturdy footwear at all times when operating the machine.
Avoid using the machine in bad weather, especially when there is a risk of lightning.
Operate the machine only in daylight or in good artifi cial lighting.
Never operate the machine with damaged guards or enclosures or without the guards or
enclosures in place.
Only switch on the motor when hands and feet are away from the cutting unit.
Always disconnect the machine from the power supply (i.e. pull the plug out of the mains,
remove the lockout device or the removable battery)
- whenever the machine is left unattended;
- before the obstruction is removed;
- before checking, cleaning or working with the machine:
- after hitting a foreign object;
- if the machine starts to vibrate excessively.
Take care not to injure the feet and hands with the cutting unit.
Always make sure that the vents are free of dirt.
When working, the power cord must be hidden in the grass; therefore, its accidental damage
or cutting is possible. If the power cord is damaged or tangled, turn off the machine with the
switch and unplug it from the mains.
When working with the machine, do not tilt and keep balance at all times. Always place your
feet fi rmly on the slope and walk, never run. When trimming a slope, always move across it,
never along.
Never touch the dangerous moving parts before disconnecting the machine from the power
supply and until all dangerous moving parts stop.
The cutting element rotates for some time after the motor is stopped.
Disconnecting the machine from the power supply requires turning it off with the power
switch and disconnecting the power source. In the case of mains-powered devices, it is
done by disconnecting the power cord plug from the mains socket. However, in the case of
battery-powered devices, it is done by disconnecting the battery.
Do not expose the machine to precipitation. The machine is not protected against ingress of
water. Water which enters the machine can cause a short-circuit which can cause electric
shock and serious injury.
Read the instructions on stopping the device in case of emergency.

Maintenance and storage

Disconnect the machine from mains (i.e. pull the plug out of the mains, remove the lockout
device or the removable battery) before carrying out any maintenance or cleaning.
Use spare parts and equipment recommended by the manufacturer only.
Regularly inspect and maintain the machine. Repair should only be carried out at an author-
ised workshop.
When the machine is not in use, keep it out of the reach of children.
Regularly inspect the device according to the information contained in the further part of the
instructions manual. This will allow for more effi cient and safe work.
O R I G I N A L I N S T R U C T I O N S
16