Philips AC3036 Benutzerhandbuch Seite 13

2
Put the power plug in the power socket (fig
3
Within 15 seconds after power on, touch and hold
filter lifetime counter (fig
6 Storage
1
Turn off the air purifier and unplug from the power socket.
2
Clean the air purifier, particle sensor and the surface of the filter
(see chapter "Cleaning and maintenance").
3
Let all parts air dry thoroughly before storing.
4
Wrap the filter in air tight plastic bags.
5 Store the air purifier, filter in a cool, dry location.
6
Always thoroughly wash hands after handling the filter.
7 Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, contact the Consumer Care Center in your
country.
Problem
The appliance does not
work properly.
The airflow that comes
out of the air outlet is
significantly weaker
than before.
The air quality does not
improve, even though
the appliance has been
operating for a long
time�
).
{
).
|
Possible solution
The filter replacement alert has been on continuously but you have
•
not replaced the corresponding filter. As a result, the appliance is now
locked. In this case, replace the filter and long press
lifetime counter.
• The surface of the filter is dirty. Clean the surface of the filter (see the
chapter "Cleaning and maintenance").
• Check if the packing material is removed from the filter.
• The filter has not been placed in the appliance. Make sure that the filter
(FY3430/30) is properly installed.
• The particle sensor is wet. The humidity level in your room is high and
causes condensation. Make sure that the particle sensor is clean and dry
(see the chapter "Cleaning and maintenance").
• Room size is large or the outdoor air quality is poor. For optimum
purification performance, please close the doors and windows when
operating the air purifier.
• There are indoor pollution resources. For instances, smoking, cooking,
incense, perfume or alcohol.
• Filter reaches the end of life. Replace the filter with a new one.
and button for 3 seconds to reset the
to reset the filter
EN
11